Using Ascii Commands - Dalsa Spyder 3 GigE SG-10-01k80-00-R User Manual

34
•

3.2 Using ASCII Commands

All functionality available through the QuickCam GUI is also available through the serial
interface using the camera-specific three letter commands.
There are three ways to enter ASCII commands: through the QuickCam Command tab,
through the Configuration window, or through the virtual serial port. Entering
commands through the QuickCam Command window is the simplest method.
Command Window Method:
1.
2.
3.
4.
The camera responds with OK> if the command was successful or an error or warning
message as appropriate.
03-032-10158-09
To view the QuickCam User's Manual, point to Programs
QuickCam User's Manual
Open QuickCam. Refer to section
running the application.
In the Message Window:
Open the Command tab.
At the OK> prompt, enter the ASCII command. Refer to Appendix A for details on all
of the camera's available ASCII commands.
Press Enter.
3 .1 QuickCam Interface for details on installing and
2 4 5 H
Spyder 3 GigE User Manual
QuickCam
DALSA