Power Supplies; Control Inputs, Camera Link - Dalsa Piranha 2 Series User Manual

16
Pin
1
2
3

2.4 Power Supplies

The cam era requ ires a single voltage inpu t (+12V to +15V). The cam era m eets all
perform ance specifications u sing stand ard sw itching p ow er su pplies, althou gh w ell -
regu lated linear su p plies provid e optim u m perform ance. See the Perform ance
Specifications for cu rrent requ irem ents.
When setting u p the cam era's pow er su p plies follow these gu id elines:
•
•
•
See section 1.3 for pow er requ irem ents.
WARNING: It is extremely important that you apply the appropriate voltages to your camera.
!
Incorrect voltages will damage the camera. Protect the camera with a fast-blow fuse between
power supply and camera.
Visit http:/ / vfm .d alsa.com for a list of com p anies that m ake pow er su p plies that m eet
the cam era's requ irem ents. The com panies listed shou ld not be consid ered the only
choices. Many high qu ality su pplies are available from other vend ors. We assu m e no
resp onsibility for the u se of these su p plies.

2.5 Control Inputs, Camera Link

The cam era accepts control inpu ts throu gh the Cam era Link MDR26F connector.
All inputs are optional. The camera ships in exposure mode 2 and with a 5 kHz line rate. All
Camera Control (CCx) signals are in a logic HIGH state.
Line rate can be set internally u sing the serial interface. Pow er -on rate is alw ays 9600
IMPORTANT:
bau d . Data rate for the 40MH z m od el is alw ays 40MH z. Data rate for the 30MH z m od el is
This camera uses the
alw ays 30MH z.
falling edge of EXSYNC
The external control signals, EXSYN C and PRIN , are optional and enabled throu gh the
to trigger line readout,
serial interface.
unlike previous DALSA
PRIN
cameras, which used the
rising edg e.
PRIN is an optional inpu t signal u sed for exposu re control (PRIN ).
PRIN
High
Low
03-032-00493-14
All manuals and user guides at all-guides.com
H iro s e 6 -p in C irc u la r M a le
1 6
5
2
4
3
M a tin g P a rt: H IR O S E
H R 1 0 A -7 P -6 S
Description Pin
+12V to +15V 4
+12V to +15V 5
+12V to +15V 6
Protect the cam era w ith a fast-blow fu se betw een pow er su pply and cam era.
Do not u se the shield on a m u lti-cond u ctor cable for grou nd .
Keep lead s as short as p ossible to red u ce voltage d rop.
Description
GND
GND
GND
Indicates
Integration
Pixel reset
Piranha 2 User's Manual
Teledyne DALSA