Error Handling And Command List; B1 Error Handling - Dalsa Piranha 3 Series User Manual

Piranha 3 User Manual
Error Handling and
Command List

B1 Error Handling

The follow ing table lists w arning and error m essages and provid es a d escription and
possible cau se.
Table 16: Warning and Error Messages
Message
OK>
Warning 01: Outsid e
of specification>
Warning 02: Clipped
to min>
Warning 03: Clipped
to max>
Warning 04: Related
parameters
ad justed >
Warning 05: Missing
cod es – insufficient
d igital gain>
Warning 06: Missing
cod es – too much
d igital gain>
Warning 07:
Coefficient may be
inaccurate A/ D
clipping has
occurred >
Warning 08: Greater
than 1% of
coefficients have
been clipped
Message
Error 01: Internal
error xx>
Teledyne DALSA
All manuals and user guides at all-guides.com
Description
SUCCESS
Parameter accepted w as outsid e of sp ecified operating range (e.g.
gain greater than ±10 d B of factory setting).
Parameter w as clipped to the current operating range. Use GCP to
see value used .
Parameter w as clipped to the current oper ating range. Use GCP to
see value used .
Parameter w as clipped to the current operating range. Use GCP to
see value used .
Output w hen the d igital gain is such that missing cod es are to be
expected d ue to not enough d igital gain.
Output w hen the d igital gain is such that missing cod es are to be
expected d ue to too much d igital gain.
In the region of interest (ROI) greater than 6.251% single or 1% of
averaged pixel values w ere zero or saturated .
A FPN/ PRNU has been calculated to be greater than the maximum
allow able 511 (8).
Description
Output only in ―d iagnostic mod e‖ or self check at pow er or reset
camera. Where xx is a cod e.
Appendix B
75
03-032-10216-06