Installing An Additional Hotswap Power Supply Module; Figure 99. Removing Power Supply Filler Panel; Figure 100. Installing Additional Hotswap Power Supply Module - Intel P4000M Service Manual

Installing an Additional Hotswap Power Supply
Module
/
NOTE
This install procedure only applies to a chassis with redundant power supply capability.
WARNING
Hazardous voltage, current, and energy levels are present inside the power supply. There are no
user-serviceable parts inside it; servicing should be done by technically qualified personnel.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Insert finger into finger hole in middle of filler panel and remove the filler panel from chassis.
3.
Insert the power supply module into the power supply cage and push all the way until it clicks into
place.

Figure 100. Installing Additional Hotswap Power Supply Module

®
Intel Server Chassis P4000M Service Guide

Figure 99. Removing Power Supply Filler Panel

Hardware Installations and Upgrades
61