Table of Contents
Advertisement
Installing PCI Add-in Board(s)
CAUTION
You may want to install an operating system before installing any add-in boards.
Do not overload the server board by installing add-in boards that draw excessive current.
Add-in boards can be extremely sensitive to ESD and always require careful handling. After
removing the board from its protective wrapper, place it component side up on a grounded, static-
free surface. Do not slide the board over any surface.
1.
Observe the safety and ESD precautions at the beginning of this book.
2.
Power down the server and unplug all peripheral devices and the AC power cable.
3.
Remove the chassis cover. For instructions, see "Removing the Chassis Cover".
4.
Remove the airduct if it is installed.
5.
Remove the PCI slot shield (see letter A) by pushing from the shield out from inside the chassis.
6.
If the PCI card is a double width card, install the optional double width card fixture (see letter B). See
Installing a Double Width Card Extension Bracket" for additional information on using double
""
width cards. It is on page 60.
7.
Rotate the PCI card retainer all the way up (see letter C).
8.
From within the chassis, press open the back panel PCI add-in board retention device (see letter D).
®
Intel
Server Chassis P4000M Service Guide
Figure 86. Removing the PCI slot shield
Figure 87. Rotate the PCI card retainer
Hardware Installations and Upgrades
55
Advertisement
Table of Contents
