Installing 2.5" Hotswap Hard Disk Drive In 2.5'' Hdd Carrier; Figure 78. Sliding The 2.5'' Hdd Carrier From The Chassis; Figure 79. Removing The Plastic Retention Device From Carrier - Intel P4000M Service Manual

Installing 2.5" Hotswap Hard Disk Drive in 2.5'' HDD Carrier

1. Open the Hotswap HDD door.
2. Remove the drive carrier by pressing the green latch to unlock and pull out the black lever (see letter A).
3. Slide the carrier out (see letter B).
4. Remove the four screws securing the plastic retention drive from the 2.5'' HDD carrier (see letter C)
5. Disengage the plastic retention device from the HDD carrier (see letter D).
6. Remove the plastic retention device from the 2.5'' HDD carrier (see letter E).
®
Intel Server Chassis P4000M Service Guide
Figure 78. Sliding the 2.5

Figure 79. Removing the plastic retention device from Carrier

Hardware Installations and Upgrades
HDD Carrier from the chassis
''
51