Installing A Hard Disk Drive Into 3.5" Hot Swap Hard Drive Carrier; Figure 48. Installing Hard Disk Drive - Removing 3.5" Hdd Carrier; Figure 49. Installing Hard Disk Drive - Removing 3.5" Hdd Interface Bracket; Figure 50. Installing Hard Disk Drive - Installing 3.5" Hdd - Intel R2000LH2 Service Manual

Installing a Hard Disk Drive into 3.5" Hot Swap Hard Drive Carrier

1. Remove the drive carrier by pressing the green button and opening the lever (see letter A).
Slide the carrier out (see letter B).
Figure 48. Installing Hard Disk Drive – Removing 3.5" HDD carrier
2. Remove the four screws securing the HDD interface bracket and remove the HDD interface
bracket (see letter C).
Figure 49. Installing Hard Disk Drive – Removing 3.5" HDD interface bracket
3. Install the hard disk drive using the same four screws as shown. Make sure the connector end of
the drive matches the backplane connector (see letter D).
Figure 50. Installing Hard Disk Drive – Installing 3.5" HDD
For installing 2.5" Hard Disk Drive as an option:
Break off the tab on the HDD interface bracket (see letter d1). Install the HDD interface bracket
from top. Secure the bracket with three screws as shown (see letter d2). Slide the 2.5" HDD
®
Intel Server System R2000LH2/LT2 Service Guide
Hardware Installations and Upgrades
33