Yealink SIP-T2 Series Provisioning Manual page 95

Permitted
Parameter
Values
network.pc_p
ort.dhcp_serv 0 or 1
er =
network.dhcp.
IP address
start_ip =
network.dhcp.
IP address
end_ip =
network.intern
et_port.speed 0, 1, 2, 3 or 4
_duplex =
network.pc_p
ort.speed_dup 0, 1, 2, 3 or 4
lex =
network.vlan.i
0 or 1
nternet_port_e
Descriptions
It enables or disables the phone to act
as a DHCP server when the PC (LAN)
port is configured as Router.
0-Disabled
1-Enabled
The default value is 1.
It takes effect after a reboot.
It configures the start IP address of the
DHCP IP segment.
The default value is 10.0.0.10.
It takes effect after a reboot.
It configures the end IP address of the
DHCP IP segment.
The default value is 10.0.0.100.
It takes effect after a reboot.
It configures the transmission mode
and speed of the Internet (WAN) port.
0-Auto negotiate
1-Full duplex 10Mbps
2-Full duplex 100Mbps
3-Half duplex 10Mbps
4-Half duplex 100Mbps
The default value is 0.
It takes effect after a reboot.
It configures the transmission mode
and speed of the PC (LAN) port.
0-Auto negotiate
1-Full duplex 10Mbps
2-Full duplex 100Mbps
3-Half duplex 10Mbps
4-Half duplex 100Mbps
The default value is 0.
It takes effect after a reboot.
It enables or disables VLAN of the
Internet (WAN) port.
Appendix
Web Setting Path
Network->PC Port
->PC Port Config
->As Router
->Enable DHCP
Server
Network->PC Port
->PC Port Config
->As Router->Start
IP Address
Network->PC Port
->PC Port Config
->As Router->End
IP Address
Network->
Advanced->Port
Link-> WAN Port
Link
Network->
Advanced->Port
Link->PC Port Link
Network->
Advanced->VLAN
85