Yealink SIP-T2 Series Provisioning Manual page 158

Yealink IP Phones Auto provisioning Guide
Permitted
Parameter
features.send
_key_tone =
features.key_t
one =
features.play_
hold_tone.ena
ble =
features.play_
Integer from
hold_tone.del
ay =
features.redial
_tone =
148
Values
The default value is 1.
Note: The old parameter
"features.pound_key.mode" is also
applicable to IP phones.
It enables or disables the phone to
play key tone when pressing the send
key.
0 or 1
0-Disabled
1-Enabled
The default value is 1.
It enables or disables the phone to
play key tone when pressing any key.
0-Disabled
0 or 1
1-Enabled
The default value is 1.
It enables or disables the phone to
play a warning tone when there is a
call on hold.
0 or 1
0-Disabled
1-Enabled
The default value is 1.
It configures the interval (in seconds)
for playing a hold warning tone.
3 to 3600
The default value is 30.
It configures the phone to continue to
play the dial tone after inputting the
preset numbers in the dialing screen.
Example:
features.redial_tone = 125
Integer
The phone will continue to play the dial
within 6
tone after inputting "125" in the dialing
digits
screen.
If it is left blank, the phone will not play
the dial tone after inputting numbers in
the dialing screen.
The default value is blank.
Descriptions Web Setting Path
Features->Audio-
> Send Sound
Features->Audio-
> Key Tone
Features->General
Information->Play
Hold Tone
Features->General
Information->Play
Hold Tone Delay
Features->Audio-
>Redial Tone