Yealink SIP-T2 Series Provisioning Manual page 161

Permitted
Parameter
Values
phone_setting
.hold_and_hel
d_power_led_ 0 or 1
flash_enable
=
phone_setting
.talk_and_dial
0 or 1
_power_led_e
nable =
features.relog Integer from
_offtime = 1 to 1000
features.direct
_ip_call_enabl 0 or 1
e =
Descriptions
If it is set to 0, the status of the power
indicator LED is determined by the
value of the parameter
"phone_setting.common_power_led_e
nable".
It enables or disables the power
indicator LED to flash when a call is
placed on hold or is held.
0-Disabled (power indicator LED does
not flash)
1-Enabled (power indicator LED fast
flashes (500ms) green)
The default value is 0.
If it is set to 0, the status of the power
indicator LED is determined by the
value of the parameter
"phone_setting.common_power_led_e
nable".
It enables or disables the power
indicator LED to be turned on when the
phone is busy.
0-Disabled (power indicator LED is off)
1-Enabled ( power indicator LED is
solid green)
The default value is 1.
If it is set to 0, the status of the power
indicator LED is determined by the
value of the parameter
"phone_setting.common_power_led_e
nable".
It configures the web access timeout
(in minutes).
The default value is 5.
It takes effect after a reboot.
It enables or disables the phone to
make an IP call directly.
0-Disabled
Appendix
Web Setting Path
Features->Power
LED->Hold/Held
Power Light On
Features->Power
LED->Talk/Dial
Power Light On
Features->General
Information->Auto-
Logout Time
(1~1000min)
Features->General
Information->
Allow IP Call
151