Configuring Lan Teaming - Fujitsu PRIMERGY TX1320 M5 Upgrade And Maintenance Manual

Basic software procedures
5.3.16

Configuring LAN teaming

Using Infrastructure Manager
When using Infrastructure Manager and replacing LAN controller or system
board, you have to deapply the profile before replacing and apply the profile
again after replacing.
Please refer to the following manuals of the Infrastructure Manager.
See manual "FUJITSU Software Infrastructure Manager V2.7.0 User's
Guide", section "2.4.2 Profiles and Policies", available at:
https://ts.fujitsu.com/support/
For Japan:
See manual "FUJITSU Software Infrastructure Manager V2.7.0 解説書",
section "2.4.2 プロファイルとポリシー", available at:
https://www.fujitsu.com/jp/products/software/infrastructure-software/
infrastructure-software/serverviewism/technical/
After replacing or upgrading LAN controllers
You need to restore the configuration for the LAN Teaming, using the LAN
driver utility or OS teaming software.
▶ Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
For more information, see the relevant LAN driver manual.
After replacing a system board
The following procedure must be done for each system board that is
replaced.
▶ Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
▶ If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility or OS teaming software.
98 Upgrade and Maintenance Manual TX1320 M5