To Connect To The System Console; To Perform A Normal System Initialization - Fujitsu Sparc Enterprise T5120 Installation Manual

Related Information
"To Connect to the System Console" on page 58
■

▼ To Connect to the System Console

Output from POST, OpenBoot, and the Solaris OS is displayed in the system console
using the network console on the service processor.
●
Type the start /SP/console command.
Multiple users can be connected to the console, but only one can be attached.
-> start /SP/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started.
Note – For more information about POST output, refer to the SPARC Enterprise
T5120 and T5220 Servers Service Manual.
Related Information
"To Perform a Normal System Initialization" on page 58
■
SPARC Enterprise T5120 and T5220 Servers Service Manual
■

▼ To Perform a Normal System Initialization

1. Type the start /SYS command.
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
Starting /SYS
58 SPARC Enterprise T5120 and T5220 Servers Installation Guide • July 2009
To stop, type #.