Fujitsu Sparc Enterprise T5120 Installation Manual page 59

Service Processor Network Management Port – Rear Panel
FIGURE:
Note – This port is not operational until you configure the network settings (through
the serial management port), as detailed in "To Configure the Service Processor
Network Management Port" on page 52.
Note – If you have access to a DHCP server on the network, you can see the service
processor get an IP address because the DHCP client is enabled by default.
Note – The service processor network management port is configured by default to
retrieve network settings with Dynamic Host Configuration Protocol (DHCP) and
allow connections using Solaris Secure Shell (SSH). You might need to modify these
settings for your network. Instructions are given in "Powering On the System" on
page 43.
Related Information
"To Connect the Ethernet Network Cables" on page 38
■
Installing the SPARC Enterprise T5120 and T5220 Servers 37