To Configure The Service Processor Network Management Port - Fujitsu Sparc Enterprise T5120 Installation Manual

Warning: password is set to factory default.
-> set /SP/users/root password
Enter new password: ********
Enter new password again: ********
->
Note – After the root password has been set, on subsequent reboots, the ILOM CLI
login prompt is displayed.
2. Enter root for the login name followed by your password.
...
hostname login: root
Password: password (nothing displayed)
Waiting for daemons to initialize...
Daemons ready
Integrated Lights Out Manager
Version 2.0.0.0
Copyright 2007 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
->
Related Information
"To Configure the Service Processor Network Management Port" on page 52
■
SPARC Enterprise T5120 and T5220 Servers Administration Guide
■
▼ To Configure the Service Processor Network
Management Port
Note – If your network allows the use of DHCP, this configuration is performed
automatically the first time you boot the system.
Use this procedure only when:
You are unable to use DHCP on your network.
■
52 SPARC Enterprise T5120 and T5220 Servers Installation Guide • July 2009