Switching Between The System Controller And The System Console; Figure 1-5 Separate System Console And System Controller Channels - Fujitsu SPARC Enterprise T2000 Administration Manual

Switching Between the System
Controller and the System Console
The system controller features two management ports, labeled SER MGT and NET
MGT, located on the server's back panel. If the system console is directed to use the
serial management and network management ports (the default configuration), these
ports provide access to both the system console and the ALOM CMT command-line
interface (the ALOM CMT prompt), each on a separate channel (see
ok
#
System console prompt
FIGURE 1-5
If the system console is configured to be accessible from the serial management and
network management ports, when you connect through one of these ports you can
access either the ALOM CMT command-line interface or the system console. You can
switch between the ALOM CMT prompt and the system console at any time, but
you cannot access both at the same time from a single terminal window or shell tool.
18 SPARC Enterprise T2000 Server Administration Guide • April 2007
Network management or
Serial management port
console
Separate System Console and System Controller Channels
sc>
#.
System controller prompt
).
FIGURE 1-5