To Connect The Ethernet Network Cables; To Connect The Ac Power Cable To The Server - Fujitsu Sparc Enterprise T5120 Installation Manual

▼ To Connect the Ethernet Network
Cables
The server has four network connectors, marked NET0, NET1, NET2, and NET3.
These connectors are RJ-45 Gigabit Ethernet.
1. Connect a Category 5 cable from your network switch or hub to Ethernet Port 0
(NET0) on the rear of the chassis.
NET0 is the farthest left port in the 4-port network cluster.
2. Connect Category 5 cables from your network switch or hub to the remaining
Ethernet ports (NET1, NET2, NET3), as needed.
FIGURE:
Related Information
"To Connect the AC Power Cable to the Server" on page 38
■

▼ To Connect the AC Power Cable to the Server

Powering on the system for the first time requires special preparation and
procedures. For example, if you have not prepared a display before connecting the
AC power cable, system messages might be lost.
38 SPARC Enterprise T5120 and T5220 Servers Installation Guide • July 2009
Service Processor Ethernet Network Ports – Rear Panel