Switching Between The System Console And Alom; Service-Related Alom Cmt Commands; Table 3-4 Service-Related Alom Cmt Commands - Fujitsu SPARC Enterprise T1000 Service Manual

3.3.1.2

Switching Between the System Console and ALOM

To switch from the console output to the ALOM CMT sc> prompt, type #.
■
(Hash-Period). Note that this command is user-configureable. Refer to the
Advanced Lights Out Management (ALOM) CMT Guide for more information.
To switch from the sc> prompt to the console, type console.
■
3.3.1.3

Service-Related ALOM CMT Commands

TABLE 3-4
descriptions of all ALOM CMT commands, issue the help command or refer to the
Advanced Lights Out Management (ALOM) CMT Guide.
Service-Related ALOM CMT Commands
TABLE 3-4
ALOM CMT Command
help [command]
break [-y][-c][-D]
clearfault UUID
console [-f]
consolehistory [-b lines|-e
lines|-v] [-g lines]
[boot|run]
bootmode
[normal|reset_nvram|
bootscript=string]
3-14 SPARC Enterprise T1000 Server Service Manual • April 2007
describes the typical ALOM CMT commands for servicing the server. For
Description
Displays a list of all ALOM CMT commands with syntax and descriptions.
Specifying a command name as an option displays help for that command.
Takes the host server from the OS to either kmdb or OpenBoot PROM
(equivalent to a Stop-A), depending on the mode Solaris software was
booted.
• -y skips the confirmation question
• -c executes a console command after the break command completes
• -D forces a core dump of the Solaris OS
Manually clears host-detected faults. The UUID is the unique fault ID of
the fault to be cleared.
Connects you to the host system. The -f option forces the console to have
read and write capabilities.
Displays the contents of the system's console buffer. The following options
enable you to specify how the output is displayed:
• -g lines specifies the number of lines to display before pausing.
• -e lines displays n lines from the end of the buffer.
• -b lines displays n lines from beginning of buffer.
• -v displays entire buffer.
• boot|run specifies the log to display (run is the default log).
Enables control of the firmware during system initialization with the
following options:
• normal is the default boot mode.
• reset_nvram resets OpenBoot PROM parameters to their default
values.
• bootscript=string enables the passing of a string to the boot
command.