The front, middle, and rear sections form the slide rail. The middle and rear sections
■
have holes for mounting screws, and adjust to fit rack depths from 24 in. (61 cm)
to 36.5 in. (93 cm). The front section can be extended to allow movement of the
server out of the rack.
The removable mounting bracket slides 14 in. (35.5 cm) out of the slide rail, then
■
locks in place. If you unlock the mounting bracket at this point, it slides an
additional 12 in. (30 cm) before separating from the slide rail. You can then mount
the mounting bracket to the right or left side of the server chassis.
Note that there are five locks in a slide rail assembly. Four are on the mounting
■
bracket. One lock is on the front section of the slide rail. The locks are described in
"Installing the SPARC Enterprise T5120 and T5220 Servers" on page
16
SPARC Enterprise T5120 and T5220 Servers Installation Guide • July 2009
19.