Installing The Servers With The Express Rail Rackmounting Kit - Fujitsu Sparc Enterprise T5120 Installation Manual

Installing the Servers With the
Express Rail Rackmounting Kit
This section provides instructions for installing the servers in an equipment rack
with express (snap-in) rails. The express rail rackmounting kit installs quickly, and
does not require mounting screws or nuts. The kit and the installation procedures are
the same for both the SPARC Enterprise T5120 and T5220 servers.
Note - If your rackmounting kit came with its own instructions, use the instructions
in your rackmounting kit instead of the instructions in this section. After performing
the server installation, proceed to
first-time power on.
Note - The procedures in this section are the same for both the 1U and 2U servers.
The illustrations show a 2U server only as an example.
This chapter contains the following sections:
"Slide Rail Assembly Notes for the Express Rail Rackmounting Kit" on page 74
■
"Installing the Servers in a Rack With Express Rails" on page 76
■
"Installing the Cable Management Arm" on page 83
■
"Dismounting the Server" on page 84
■
Note - References to left and right are from your viewpoint as you face either the
front or the rear of the system.
Related Information
"Slide Rail Assembly Notes for the Express Rail Rackmounting Kit" on page 74
■
"Installing the Servers in a Rack With Express Rails" on page 76
■
"Powering On the System" on page 43 for
73