Fujitsu Sparc Enterprise T5120 Installation Manual page 70

8. When prompted, follow the onscreen instructions for configuring the Solaris
Operating System on your host and enter the following configuration
information.
You will be prompted to confirm the configuration several times, enabling
confirmation and changes. If you are not sure how to respond to a particular
value, you can accept the default, and make future changes when the Solaris OS is
running.
Parameter
Language
Locale
Terminal Type
Network?
Multiple Network
Interfaces
DHCP?
Host Name
IP Address
Subnet?
Subnet Netmask
IPv6?
Security Policy
Confirm
Name Service
NFSv4 Domain Name
Time Zone (Continent)
Time Zone (Country or
Region)
48 SPARC Enterprise T5120 and T5220 Servers Installation Guide • July 2009
Description
Select a number from the displayed language list.
Select a number from the displayed locale list.
Select a terminal type that corresponds with your terminal device.
Select Yes.
Select the network interfaces that you plan to configure. If you are not sure, select
the first one in the list.
Select Yes or No according to your network environment.
Enter the host name for the server.
Enter the IP address for this Ethernet interface.
Select Yes or No according to your network environment.
(If subnet was Yes) Enter the netmask for the subnet for your network
environment.
Specify whether or not to use IPv6. If you are not sure, select No to configure the
Ethernet interface for IPv4.
Select either standard UNIX security (No) or Kerberos Security (Yes). If you are not
sure, select No.
Review the onscreen information and change it if needed. Otherwise, continue.
Select the name service according to your network environment.
Note–If you select a name service other than None, you will be prompted for
additional name service configuration information.
Select the type of domain name configuration according to your environment. If
you are not sure, select Use the NFSv4 domain derived by the system.
Select your continent.
Select your country or region.