Caution – Finish the hardware procedures in this chapter, but do not attach the AC
power cable yet.
Powering on the system for the first time requires special preparation and
procedures. For example, if you have not prepared a display before connecting the
AC power cable, system messages could be lost.
Caution – The server goes into Standby mode and the service processor initializes as
soon as the AC power cable is connected to the power source.
●
Go to
"Powering On the System for the First Time" on page 43
on connecting the server to AC power.
Related Information
"Powering On the System for the First Time" on page 43
■
Managing Cables With the CMA
Managing the cables with the CMA is the same for both servers.
Related Information
"To Secure the Server Cables in the CMA" on page 39
■
▼ To Secure the Server Cables in the CMA
●
Once the server cables are connected and placed inside the CMA, open the
velcro cable straps and wrap the straps around the CMA securing the cables
inside the CMA.
Installing the SPARC Enterprise T5120 and T5220 Servers
for instructions
39