Fujitsu Sparc Enterprise T5120 Installation Manual page 46

6. Attach a slide rail to the right front rack post.
a. Loosely attach the front of a slide rail to the right front rack post using two
Note – Do not tighten the screws yet.
FIGURE:
b. Adjust the length of the slide rail by sliding the rear mounting flange to
c. Loosely attach the rear of the slide rail to the rear rack post with two screws.
7. Attach the second slide rail to the left rack posts in a similar manner.
Do not tighten the screws.
8. Use the slide rail spacing tool to adjust the distance between the slide rails.
a. At the front of the rack, plug the left side of the tool into slots at the end of
24 SPARC Enterprise T5120 and T5220 Servers Installation Guide • July 2009
screws.
Mounting a Slide Rail (Either Server)
reach the outside edge of the rear rack post.
the left rail.