To Connect The Dc Input Power Cords - Fujitsu Sparc Enterprise T5120 Installation Manual
Hide thumbs
Also See for Sparc Enterprise T5120:
- Product notes (150 pages) ,
- Safety and compliance manual (34 pages) ,
- Overview manual (34 pages)
Table of Contents
Advertisement
FIGURE:
Figure Legend
Note – If you need to remove a wire from the DC input plug, insert the cage clamp
operating tool or a small screwdriver into the slot directly above the wire and push
in. Pull the wire from the DC input plug.
7. Remove the cage clamp tool to secure the wire.
8. Repeat
DC input power cable.
9. Repeat this procedure to create as many DC input power cables as you need for
your unit.
▼ To Connect the DC Input Power Cords
1. Ensure that the circuit breaker to your power source is turned off.
104
SPARC Enterprise T5120 and T5220 Servers Installation Guide • July 2009
Connector Wiring Assignments
1
From -48V or -60V
2
From Chassis ground (green/yellow)
3
From -48V or -60V Return
Step 5
and
Step 6
for the other two wires to complete the assembly of the
Advertisement
Table of Contents
