Connecting The Embedded Switch Module To The Ethernet Network25; Connecting The Embedded Switch Module Through An Internal Port; Connecting The Embedded Switch Module To The Ethernet Network - Fujitsu PRIMERGY BX900 Hardware Reference Manual

5. Perform the appropriate action based on whether you are using DHCP.
6. Click the Reload Settings button to view the new IP address. It could take up to three minutes
NOTE
Refer to the PRIMERGY BX900 Management Blade User Guide for additional details.

Connecting the Embedded Switch Module to the Ethernet network

The Embedded Switch Module has one external port and two internal ports that interact with the
chassis. Once you have successfully set the appropriate IP address of the Embedded Switch
Module, you can establish an Ethernet connection using one of two methods:
•
•

Connecting the Embedded Switch Module through an internal port

The internal Ethernet connection is the default configuration and no action is required.
Figure 10
FIGURE 10
Brocade 5450 Hardware Reference Manual
53-1001266-02
Connecting the Embedded Switch Module to the Ethernet network
•
If you are using DHCP, enable it by selecting DHCP enable and clicking Apply.
•
If you are not using DHCP, uncheck the DHCP Enable check box, enter the appropriate
information in the IP Address, Subnet Mask, and Gateway fields, and click Apply.
for the settings to reload.
The PRIMERGY BX900 Management Blade application through an internal port.
Through the external Fabric port.
shows the default port control setting on the PRIMERGY BX900 Management port.
PRIMERGY BX900 Management Port Control defaults to Internal Port
3
25