Table 60: Boot Bios Messages; Table 61: Storage Device Bios Messages - Intel SE7520JR2 Technical Manual

Intel® Server Board SE7520JR2
Gate20 Error
Multi-Bit ECC Error
Parity Error
Message Displayed
Boot Failure ...
Invalid Boot Diskette
Drive Not Ready
A: Drive Error
B: Drive Error
Insert BOOT diskette in A:
Reboot and Select proper Boot device or Insert Boot
Media in selected Boot device
NO ROM BASIC
Message Displayed
Primary Master Hard Disk Error
Revision 1.0

Table 60: Boot BIOS Messages

Table 61: Storage Device BIOS Messages

C78844-002
Error Reporting and Handling
The BIOS is unable to properly control the motherboard's
Gate A20 function, which controls access of memory
over 1 MB. This may indicate a problem with the
motherboard.
This message will only occur on systems using ECC
enabled memory modules. ECC memory has the ability
to correct single-bit errors that may occur from faulty
memory modules.
A multiple bit corruption of memory has occurred, and the
ECC memory algorithm cannot correct it. This may
indicate a defective memory module.
Fatal Memory Parity Error. System halts after displaying
this message.
Description
This is a generic message indicating the BIOS could not
boot from a particular device. This message is usually
followed by other information concerning the device.
A diskette was found in the drive, but it is not configured
as a bootable diskette.
The BIOS was unable to access the drive because it
indicated it was not ready for data transfer. This is often
reported by drives when no media is present.
The BIOS attempted to configure the A: drive during
POST, but was unable to properly configure the device.
This may be due to a bad cable or faulty diskette drive.
The BIOS attempted to configure the B: drive during
POST, but was unable to properly configure the device.
This may be due to a bad cable or faulty diskette drive.
The BIOS attempted to boot from the A: drive, but could
not find a proper boot diskette.
BIOS could not find a bootable device in the system
and/or removable media drive does not contain media.
This message occurs on some systems when no
bootable device can be detected.
Description
The IDE/ATAPI device configured as Primary Master
could not be properly initialized by the BIOS. This
message is typically displayed when the BIOS is trying to
157