Compaq AlphaServer GS60 Operation Manual page 187

Table 7-3 Environment Variables (Continued)
Variable
boot_reset
console
cpu
cpu_enabled
cpu_primary
d_harderr
d_report
d_softerr
d_trace
dump_dev
Attribute Function
Nonvolatile For OpenVMS and DIGITAL UNIX systems,
the default file name used for the primary
bootstrap when no file name is specified in
the boot command. Not used with Windows
NT.
Nonvolatile Defines the type of console device.
serial A serial console terminal
graphics A graphics console device
both Both a serial and graphics console
device
Nonvolatile Selects the current boot processor.
Nonvolatile A bitmask indicating which processors are
enabled to run (leave console mode). Default
is 0xffff.
Nonvolatile A bitmask indicating which processors are
enabled to become the next boot processor,
following the next reset. Default is 0xffff.
Volatile Determines action taken following a hard
error. Values are halt (default) and continue.
Applies only when using test.
Volatile Determines level of information provided by
the diagnostic reports. Values are summary
and full (default). Applies only when using
test.
Volatile Determines action taken following a soft
error. Values are continue (default) and halt.
Applies only when using test.
Nonvolatile Specifies whether or not to display test trace
messages.
off (default) - Disables trace messages
on - Enables trace messages
Nonvolatile Device to which dump file is written if the
system crashes, if supported by the operating
system.
(Continued on next page)
SRM Console Commands 7-11