Compaq AlphaServer GS60 Operation Manual page 107

Example 5-7 Show Config and Show Device Commands
(Continued)
dkb300.3.0.7.1
dkb400.4.0.7.1
dkb600.6.0.7.1
polling for units on kzpsa2, slot 9, bus 0, hose1...
kzpsa2.7.0.9.1
dkc200.2.0.9.1
dkc400.4.0.9.1
dkc600.6.0.9.1
polling for units on isp0, slot 6, bus 0, hose3...
dkd300.3.0.6.3
dkd500.5.0.6.3
polling for units on kzpaa0, slot 8, bus 0, hose3...
pke0.7.0.8.3
dke500.5.0.8.3
polling for units on kzpsa3, slot 9, bus 0, hose3...
kzpsa3.7.0.9.3
dkf200.2.0.9.3
dkf300.3.0.9.3
dkf500.5.0.9.3
P08>>>
The RRD46 is a CD-ROM disk drive, where you load firmware update CD-ROM
disks. You can use the boot command to boot LFU from the disk. In this
example, the command would be:
P08>>> boot dke500
If you are not planning to use the default boot device selected for your factory-installed
software (FIS), or if your OpenVMS or DIGITAL UNIX operating system is not
factory installed, you select an appropriate boot device for your system. Use the show
config and show device SRM console commands to display all the I/O adapters and
devices on your system. The format for SRM console device names is:
ddau.n.c.s.h
where the fields are as defined in Table 5-2.
DKB300
DKB400
DKB600
dkc TPwr 1 Fast 1 Bus ID 7
DKC200
DKC400
DKC600
DKD300
DKD500
kzpaa4
DKE500
dkf TPwr 1 Fast 1 Bus ID 7
DKF200
DKF300
DKF500
Booting an Operating System 5-9
RZ28M 0568
RZ28M 0568
RZ28M 0568
P01
RZ28M 0568
RZ28M 0568
RZ28M 0568
RZ1DB-CA LYJ0
RZ28M 0568
SCSI Bus ID 7
RRD46 0557
F01
RZ29B 0016
RZ28 T436
RZ28M 0568
A10
A11