Compaq AlphaServer GS60 Operation Manual page 163

In Example 6-14:
At the console prompt, the operator enters a test -t 180 command. The option
-t specifies a system test run time of 180 seconds.
To stop execution of the test command before normal completion, use Ctrl/C
(^C). Termination using ^C may take a number of seconds depending upon the
particular configuration being tested.
Status messages indicate the start of the console-based exercisers.
The exercisers run for 180 seconds; not enough time to test the entire system,
so this status message is displayed.
All exercisers are stopped, as indicated by the status messages.
The console prompt returns.
System Troubleshooting 6-41