Power-Up Beep Control - Datalogic MAGELLAN 8300 Product Reference Manual

Power-up Beep Control

Product Reference Guide
Specifies the type of audible indication that is made when entering scan-
ner-active mode on power-up. Choices are:
• No beep
• One beep
• Three beeps
To set the Power-up Beep:
1. Scan the SWITCH bar code.
2. Scan your selection from the three bar codes below. You'll need to
cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
POWER-UP BEEP = ONE BEEP
POWER-UP BEEP = OFF
Indication Features
6-33