Waste Drain Ink Pad Unit Removal - Epson STYLUS COLOR 480 Service Manual

EPSON Stylus COLOR 480

4.2.5 Waste drain ink pad unit removal

1. Remove the Housing from the printer. (Section 4.2.1 Housing removal)
2. Remove one screw (C.B.P TITE 3x8 F/Zn screw) on the front right side of the printer.
(viewed from front side)
Figure 4-17. Removing one screw securing the Waste ink pad unit
3. Remove one screw (C.B.P. TITE 3x8 F/Zn screw) and take three cables off from the
cable hook in the Waste drain ink pad unit as shown in the following figure.
Peel off the adhesive tape
Figure 4-18. Removing one screws & cables at the back side of the printer
4. Remove the Waste drain ink pad unit from the printer
Disassembly and Assembly
C.B.T TITE 3x8 F/Zn screw
C.B.S. TITE 3X8 F/Zn screw
Cable holder
.
n
After assembling the Waste drain ink pad unit, be sure to set the
following three cables in the cable hook in the Waste drain ink
pad unit. Refer to the Figure 4-18.
n
When assembling the Waste drain ink pad unit, be sure to set the
tip of the waste ink tube in the suitable position of the Waste
drain ink pad. Refer to the Figure 4-19
Pump unit
Figure 4-19. Drain ink tube setting position
When the Waste drain ink pad is replaced with a new one,
following service item is required.
n
Waste drain ink counter reset operation. Refer to Page116.
n
Tightening torque for screw
• C.B.P. TITE 3x8 screw for Waste drain ink pad unit
Disassembly
Revision B
Waste drain ink pad
Ink tube
: 9+/1 kgf.cm
80