Table 2-1. 5Kw To 15Kw And 20Kw To 30Kw Series Input/Output Connectors; Table 2-2. Input Connections; Table 2-3. Output Connections - Ametek SPS A Series Operation Manual

AMREL SPS-A Series
Connector
FL1 – AC
FL1 – AC
FL1 – AC
Chassis - GND
Pos. Bus Bar
Neg. Bus Bar
Pos. Bus Bar
Neg. Bus Bar
ANALOG CONTROL
Connector (J1)
Sense Connector
Parallel In-Out
Table 2–1. 5kW to 15kW and 20kW to 30kW Series Input/Output Connectors
Power Supply Type
4 kW to 15 kW
20 kW to 30 kW
Power Supply Type
4 kW to 15 kW
5 kW to 15 kW
20 kW to 30 kW
CAUTION!
Prevent damage to the unit: follow torque specifications, use correct size
wire ferrule (if used), and proper size ferrule crimping tool.
T S
ORQUE
•
The unit's Phoenix Connectors require 18 in-lb to 20 in-lb (2 Nm to
2.3 Nm) torque.
•
Wire ferrules are recommended; their size must match the wire
gauge.
•
Crimp tool size must be appropriate to the ferrule size.
•
Wire insulation should be stripped back no more than 5/8 inch for the
ferrule.
M550129-01 Rev A
Prime AC Power Input
See Table 2–2.
Not phase rotation sensitive. Neutral not
used.
Output Power:
3U models (see Table 2–3)
6U models (see Table 2–3)
Control Interface
Used for remote sense
Used for parallel operation
Feed through high current terminal block
Bus Bar with holes for 1/4"–20 bolts
Table 2–2. Input Connections
Bus Bar with two holes for each potential terminal 0.594".
(Models 10V-30V)
Bus Bar with holes for 3/8" bolts (40V-600V)
Bronze studs, ¼-20 (800V model only)
Bus Bar with holes for 3/8" bolts
Bronze studs, ¼-20 (800V model only)
Table 2–3. Output Connections
PECIFICATIONS
Function
Connection Description
Connection Description
Installation
Connects To
208/220 VAC (Std)
380/400 VAC (Option)
440/480 VAC (Option)
47-63 Hz, 400 Hz
User load(s)
See Table 3–1 for
description
Refer to Section 3.6
Refer to Section 3.10
1-5