Ametek SPS A Series Operation Manual page 48

Operation
Figure 3-4 and Figure 3-5 descriptions:
1
ETHERNET Connector
2 RS232 Connector
3 ANALOG CONTROL
4 SENSE Connector
4a HV SENSE Connector
5 LAN
6 RESET Switch
7 Configuration Switch
8 External User
Connector
9 Parallel In Connector
10 Parallel Out Connector
11 Output Bus Bars
12 Ground
13 AC Input Connectors
3-6
Connector for remote control via Ethernet.
Connector for remote control
J1 I/O connector for input programming and analog output
monitoring signals as well as status indication and remote
shutdown signals. See Table 3–1 for individual pin descriptions.
J3 Input connector for load voltage sensing to correct for line
drops in the load cables (see Section 3.6).
J3 Input connector for load voltage sensing, 800V models only.
LED steady-lit indicates Network connectivity; blinking indicates
"Instrument ID" (See SG Series Programming Manual).
Returns configuration parameters to factory default settings.
Four–position DIP switch to configure the unit with a Remote
Digital Programming option.
Provides external auxiliary control signals.
Allows master/slave configuration of up to five units when
connected to another unit's Parallel Out connector
See Section 3.10.
Allows master/slave configuration of up to five units when
connected to another unit's Parallel In connector.
See Section 3.10.
Positive (+) and negative (–) outputs.
Connection for ground wire.
Connection for 3-phase AC.
AMREL SPS-A Series
M550129-01 Rev A