Ametek SPS A Series Operation Manual page 46

Operation
Figure 3-2 and Figure 3-3 descriptions:
1
RS232 Connector
2
SENSE Connector
2a HV SENSE Connector J3 Input connector for load voltage sensing, 800V models
3
ANALOG CONTROL
4
Configuration Switch Four–position DIP switch to configure the unit with a GPIB
5
Parallel In Connector Allows master/slave configuration of up to five units when
6
GPIB Connector
7
Parallel Out
Connector
8
Output Bus Bars
9
Ground
10 AC Input Connectors Connection for 3-phase AC.
3-4
Connector for remote control
J3 Input connector for load voltage sensing to correct for
line drops in the load cables (see Section 3.6).
only.
J1 I/O connector for input programming and analog output
monitoring signals as well as status indication and remote
shutdown signals. See Table 3–1 for individual pin
descriptions.
option.
connected to another unit's Parallel Out connector
See Section 3.10.
Connector for remote control.
Allows master/slave configuration of up to five units when
connected to another unit's Parallel In connector.
See Section 3.10.
Positive (+) and negative (–) outputs.
Connection for ground wire.
AMREL SPS-A Series
M550129-01 Rev A