Environmental Characteristics; Electrical Characteristics - Ametek SPS A Series Operation Manual

Overview

1.2.1 ENVIRONMENTAL CHARACTERISTICS

Parameter
Temperature
Coefficient
Ambient Temperature
Operating
Storage
Cooling
Humidity
Altitude
Agency Approvals

1.2.2 ELECTRICAL CHARACTERISTICS

The voltage accuracy specifications are valid only with remote sense connected.
Parameter
Input Power
Voltage (Standard)
Voltage (Options)
Frequency
Phases
Front Panel Meter Accuracy
Voltage
Current
Load Regulation (Specified at no load to full load, nominal AC input)
Voltage
Current
Line Regulation (Specified ±10% of nominal AC input, constant load)
Voltage
Current
Transient Response
1-2
0.02%/°C of maximum output voltage rating for voltage set point.
0.03%/°C of maximum output current rating for current set point.
0 to 50°C
-25° to 65°C
Internal fans; vents on sides and rear. (Units may be stacked without
clearance above or below).
95% maximum, non-condensing, 0 to 50°C; 45°C maximum wet-bulb
temperature.
Operating full power available up to 5,000 feet (1,524m),
derate 10% of full power for every 1,000 feet higher
non-operating to 40,000 feet (12,192m)
CE Mark to the Low Voltage and EMC directives
NRTL approved to UL 1012, UL 61010, EN 61010, IEC 61010
208/230 VAC±10% (tested to 187-253 VAC)
380/400 VAC±10% (tested to 342-440 VAC)
440/480 VAC±10% (tested to 396-528 VAC)
47 to 63 Hz, 400 Hz
3–phase, 3–wire plus ground. Not phase rotation sensitive.
Neutral not used.
±0.5% of full-scale + 1 digit
±0.5% of full-scale + 1 digit
0.02% of maximum output voltage (40V – 800V)
0.05% of maximum output voltage (10V – 30V)
0.1% of maximum output current
0.05% of maximum output voltage (10V – 30V)
0.01% of maximum output voltage (40V – 800V)
0.05% of maximum output current
A 50% step load will recover to within 0.75% of original value
AMREL SPS-A Series
Specification
Specification
M550129-01 Rev A