Figure 3-6. Sps-A 6U Rear Panel With Gpib/Rs232 Option Connectors - Ametek SPS A Series Operation Manual

AMREL SPS-A Series

Figure 3-6. SPS-A 6U Rear Panel with GPIB/RS232 Option Connectors

Figure 3-6 descriptions:
1
ANALOG CONTROL J1 I/O connector for input programming and analog output monitoring
2
SENSE Connector
3
PARALLEL IN
4
PARALLEL OUT
5
RS232 Connector
6
Configuration Switch Eight–position DIP switch to configure an SPS-A Series unit with a
7
GPIB Connector
8
AC Input Bus Bars
M550129-01 Rev A
signals as well as status indication and remote shutdown signals.
See Table 3–1 for individual pin descriptions.
J3 input connector for load voltage sensing to correct for line drops in
the load cables (see Section 3.6).
Connector allowing master/slave configuration of up to five units when
connected to another unit's PARALLEL OUT connector
(see Section 3.10).
Connector allowing master/slave configuration of up to five units when
connected to another unit's PARALLEL IN connector
(see Section 3.10).
Connector for remote control.
Remote Digital Programming option.
Note: Some models are designed with a four-position DIP switch.
Connector for remote control.
Connection for 3-phase AC and Ground.
Operation
3-7