Configuring Exceptions - HIKVISION DS-7300HWI-SH Series User Manual

3. Select the Alarm Output No. in the dropdown list.
4. Edit the Alarm Name.
5. Select the Dwell Time.
6. Setup arming schedule for the alarm output by click Handing Set. Choose one day in a week and
set an arming schedule. If the schedule can also be applied to other days, click Copy. Click Apply
to save the settings and back to the Alarm Output interface.
7. If the same setting can also be applied to other alarm output, click Copy.
8. Click Apply to save the settings.
9. You can check the alarm output status in the Alarm Output Status list in the Alarm Output
interface.

Configuring Exceptions

Actions can also be triggered when the DVR detects certain exceptions. To setup exception configuration:
1. Enter the Exception menu, shown in Figure 74 by going to Menu > System Configuration >
Exception.
2. Select the Exception Type to configure. The exception types include:

HDD Full: If selected, trigger action when HDD is full.

HDD Error: If selected, trigger action when errors on the HDD are detected.

Network Disconnected: If selected, trigger action when a network disconnected is detected.

IP Conflicted: If selected, trigger action if an IP conflicted is detected.

Illegal Login: If selected, trigger action when illegal logins are detected.

Video Signal Exception: if selected, trigger action when video signal is abnormal.

Input/Output Video Standard Mismatch: If selected, trigger action when video output
standard does not match.

Recording exception: If selected, trigger action when recording exception is detected.

All: if selected, trigger action when any one of exception above is detected.
3. Select the Actions to take when the exception is detected. More than one action can be selected.
The actions available includes:

Audible Warning: DVR will sound an audio warning if exception is detected.

Notify Surveillance Center: DVR will notify surveillance center if exception is detected.
Figure 74 Exception Configuration Menu
73