Hdd Detect - HIKVISION DS-7300HWI-SH Series User Manual

4. Click the Apply button to pop up an attention box as shown below:
5. Click Yes to reboot and make the settings effective. Click No to cancel the operation.
6. After rebooting, you can configure local HDD settings. To configure local HDD settings by going
to Menu > System Configuration > HDD > HDD Information.
1) Select a HDD and click
2) Select the HDD Property from R/W, Read-only and Redundancy. Read-only mode can
prevent important recorded files from being overwritten when the HDD becomes full in
overwrite recording mode. Redundancy mode can ensure high security and reliability by
recording the video onto the redundancy HDD and R/W HDD simultaneously.
3) Select the Group number for the current HDD. The default group number for each HDD is 1.
4) Click the Apply button to save the settings and click OK to the up level menu.
Note:
At least 2 hard disks must be installed when you want to set a HDD to Redundancy mode and one of them
with R/W property.

HDD Detect

The device provides the HDD detection function such as the adopting of the S.M.A.R.T. and the Bad
Sector Detection technique.
Figure 87 Attention for reboot
to pop up the Local HDD Settings menu as shown in Figure 88.
Figure 88 Local HDD Settings
86