Configuring Snmp - HIKVISION DS-7300HWI-SH Series User Manual

2. Check the Enable DDNS checkbox.
3. Select a DDNS type from the DDNS Type selection box. Five different DDNS types are
selectable: IPServer, DynDNS, PeanetHull, NO-IP, hkDDNS.

IPServer: Enter Server Address for IPServer.

DynDNS:
1) Enter Server Address for DynDNS.
2) Enter the domain obtained from the DynDNS website in the Domain Name textbox.
3) Enter the User Name and Password registered in the DynDNS website.

PeanutHull: Enter the User Name and Password obtained from the PeanutHull website.

NO-IP:
1) Enter Server Address for NO-IP.
2) Enter the domain obtained from the DynDNS website (www.no-ip.com) in the Domain
Name textbox.
3) Enter the User Name and Password registered in the NO-IP website.

HiDDNS:
1) The Server Address defaults to www.hik-online.com.
2) Enter the Device Domain Name. The domain name can only contain the lower-case letter,
numeric and '-', and it must start with the lower-case letter and cannot end with '-'.
3) If you have more than one device, you can register an account on
do some management.
4. Click the Apply button to save the settings.

Configuring SNMP

You can use SNMP protocol to get device status and parameters related information. To configure SNMP:
1. Select the SNMP tab to enter the SNMP settings interface, as shown in Figure 54.
Figure 53 DDNS Settings Menu
Figure 54 SNMP Settings Menu
www.hik-online.com to
58