Configuring Ptz Cameras; Configuring Basic Ptz Settings - HIKVISION DS-7300HWI-SH Series User Manual

Configuring PTZ Cameras

Configuring Basic PTZ Settings

Settings for a PTZ camera must be configured before it can be used. Before proceeding, verify that the
PTZ and RS-485 of the DVR are connected properly.
To configure PTZ settings:
1. Enter the PTZ menu, shown in Figure 63 by going to Main Menu > Cameras Setup > PTZ.
2. Select the General tab.
3. Select the camera to configure in the Camera dropdown list.
4. Configure PTZ settings, including those of Baud Rate, Data Bit, Stop Bit, Parity, Flow Ctrl, PTZ
Protocol and Address according to the parameters of the PTZ camera(s).
5. If the same configuration can be applied to other PTZ channels, click the Copy button.
6. Click the Apply button to save the settings.
To test and verify PTZ settings:
1. Enter the PTZ Configuration menu by going to Menu > Cameras Setup > PTZ.
2. Select the More Settings tab, shown in Figure 64.
Figure 63 General Settings of PTZ Configuration
65