HIKVISION DS-7300HWI-SH Series User Manual page 68

Note:
Only the first 17 presets are shown in the table. To save or recall more presets, click on the "..." button.
Clicking the "..." button will bring up a selection box for presets up to 255.
To customize PTZ patterns:
1. Enter the PTZ menu by going to Menu > Cameras Setup > PTZ.
2. Select the More Settings tab, as shown in Figure 64.
3. Select a Pattern Number to set from the dropdown list.
4. Click to begin recording the movement of the PTZ.
5. Move the PTZ to the desired locations using the PTZ control buttons.
6. Click to save pattern.
7. To test out your new pattern, click
during the recording process. You may click the stop button at any time to end the pattern.
Clicking the play button again will start playing the PTZ pattern again at the initial position.
To customize PTZ patrols:
1. Enter the PTZ menu by going to Menu > Cameras Setup > PTZ.
2. Select the More Settings tab, as shown in Figure 64.
3. Select a Patrol Number to set from the dropdown list.
4. Click to pop-up a KeyPoint box and add key point. Select a Preset Number from the
dropdown list that you would like to add to the patrol. Set the duration and speed.
5. Click the OK button. The Preset Number will be added to the patrol list.
6. Repeat steps 4-5 until you have included all the presets you would like to have on the patrol.
7. Click the Up and Down button at the bottom of the list to change the order of the presets in the
patrol.
8. To test out your new preset, click the Play and Stop button, shown as
move through the list of added presets and end the patrol when you click Stop.
to play and to stop. The PTZ should move as it did
. The PTZ should
67