Configuring Record Schedule - HIKVISION DS-7300HWI-SH Series User Manual

2. Event recordings are recordings that are triggered from motion detection and/ or from
an external alarm.
3. If an event occurs during Continuous recording, the frame rate will automatically
switch to that set for Event recording.
4. For holiday settings, you can refer to Page 43.

Configuring Record Schedule

A record schedule allows you to schedule multiple time periods per day for recording. Setting up a record
schedule will allow you to further conserve disk space by recording only during the time periods you
would like to record at.
Note:
In this chapter, we take the record schedule procedure as an example, and the same procedure can be
applied to configure capture schedule. To setting the capture schedule, choose the Capture tab in the
Schedule interface.
Steps:
1. Enter the Schedule menu, shown in Figure 32 by going to Menu > Recording Configuration >
Schedule.
2. Select the Record tab to configure record schedule.
3. Select the camera to configure from the camera dropdown list.
4. Check the Enable Schedule checkbox to enable the record schedule. If the checkbox is
unchecked, the record schedule will be disabled.
5. Edit the record schedule. There are three ways to set the record schedule:

Instant edit
1) On the Record menu, select a day from Monday to Sunday to configure schedule for.
2) Setup time periods for schedule. If the 24HR checkbox is checked, recording will occur over
the entire day. To setup multiple time periods, uncheck 24HR and enter the Start/End Time
for the selected day. The start/End time are listed using a 24 hr cycle (i.e. 18:00 is equivalent
to 6:00pm). Up to 8 discontinuous periods can be configured for each day.
Figure 32 Record Schedule Configuration Menu
39