Table of Contents
Advertisement
CDM-710G High-Speed Satellite Modem
Rear Panel Connector Pinouts
P1 Notes :
1. The relays have low voltage contacts with transient suppressors across each pin
2. The maximum working voltage is 18VDC or 13VAC. The maximum current
4.4.2
P2 Remote Port Connector (RS-232/-485), DB-9M
4.4.3
J7 External Reference Input
The Ext Ref (External Reference) input is a female BNC connector, used to supply a
master reference to the entire chassis. The clocks on the Framer Card and the
Modulator and Demodulator Synthesizers are locked to this input, when it is used.
Note that some data interfaces have an Ext-Clk input for synchronizing the data
sources. Refer to the applicable Data Interface chapter in this manual for details.
to ground. The Summary Relay combines Tx, Rx, and Unit Faults into a single
relay.
rating is 1 Amp DC or 0.5 Amp AC.
The P2 Remote port connector is a 9-pin Type 'D' male interface with threaded jack
nuts. It is intended for connection to an M&C computer or terminal device, and is
user selectable for either RS-232 or RS-485.The connector pinout is as follows:
Pin #
Description
1
Ground
2
RS-232 Transmit Data
3
RS-232 Receive Data
4
Not Used
5
Not Used
6
RS-485 Receive Data B
7
RS-485 Receive Data A
8
RS-485 Transmit Data B
9
RS-485 Transmit Data A
* Use for 2-wire RS-485 operation
Direction
-
Out
In
-
-
*
In
*
In
Out
Out
4–5
Revision 1
MN-CDM710G
Advertisement
Table of Contents
