Table of Contents
Advertisement
CDM-710G High-Speed Satellite Modem
Flash Upgrading
9. Transfer the files.
Type "put FW0000114*.bin bulk:" to begin the file transfers. The destination "bulk:" must
be all lower case. It will take approximately one minute to transfer the file.
10. Verify the file transfer.
a. The PC should report that the file transfer has occurred, and the display on the
modem will report:
Programming flash sector #xx
Please wait...
b. The process sequences through several blocks – this will take several minutes. When
it has finished, the modem front panel will display:
Bulk FTP done. Press CLEAR.
c. Terminate the FTP session by typing "bye" and closing the DOS window.
d. Verify that the new file loaded using the procedure in Step 1.
e. Change the desired image to boot from the modem font panel menu:
keypad to change to the other image, then reboot the modem.
f.
Verify the new software versions are booting by observing the following messages
on the modem display:
CDM-710G Modem
Firmware Ver x.x.x
5.3
10/100/1000 BASE-T (GigE) INTERFACE (CDI-70) FTP Upload Procedure
Refer to Chapter 14. 10/100/1000 BASE-T (GigE) INTERFACE (CDI-70) for information on
and instructions for flash upgrading this optional data interface.
5.4
USB Procedure
USB reflash is not available in this firmware release – please consult Comtech
EF Data Customer Support for release schedule.
IMPORTANT
and use the left or right arrows (◄►) on the front panel
Firmware
Select
5–4
Revision 1
MN-CDM710G
SELECT: UTIL
Advertisement
Table of Contents
