Comtech EF Data CDM-710G Installation And Operation Manual page 202

CDM-710G High-Speed Satellite Modem
Remote Control
Command Arguments for
Parameter (Instruction Command or
Type Code and Response to
Qualifier)
Redundancy RED= 1 byte
State
Gigabit Auto SCX 2 bytes
Autocrossover
Gigabit SLM 2 bytes
Learning Mode
Serial Number N/A 9 bytes
Software N/A 5 bytes
Revision
Tx Alpha Rolloff TAR= 1 byte
Tx Clock TCI= 2 bytes
Invert
Description of Arguments
Query
Command or Query.
Unit returns the redundancy state of the unit, where:
0 = Offline
1 = Online
*** This command can be used to force the unit offline, this is done by
sending RED=0. This is only valid if redundancy mode is enabled. If
redundancy is not enabled, then RED=0 will return an error. The unit
cannot be forced online.
*** If the unit is not in redundancy mode, then the unit will always be online.
Example: RED=0 (force unit offline)
Command or Query.
s=Slot2 Only
a= 1 GBEI Cable Auto Crossover Enabled.
a=0 GBEI Cable Auto Crossover Disabled
Command or Query.
s=Slot2 Only
a= 1 GBEI Learning Enabled.
a=0 GBEI Learning Disabled
Query Only.
Used to query the unit 9-digit serial number. Unit returns its S/N in the form
xxxxxxxxx.
Example: SNO=176500143
Query Only.
Unit returns the value of the internal software revision installed in the unit,
in the form: Boot:X.X.X Bulk1:Y.Y.Y Bulk2: Z.Z.Z
Example: SWR=Boot:1.0.3 Bulk1:1.0.1 Bulk2:1.0.0
Command or Query.
Tx Alpha Rolloff, where:
0 = 20%
1 = 25%
2 = 35%
Example: TAR=0 (which is a Tx Alpha Rolloff of 20%)
Command or Query.
Invert Transmit Clock, where:
s=Defines which interface slot ( 1 or 2 )
x=Invert Transmit Clock, where:
0=Normal
1=Inverted
Note: Command valid with HSSI or E3T3STS1)
Example: TCI = 11 (selects Inverted TX Clock, Slot 1)
A–12
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
RED= RED? RED=x
RED? (see description of
RED* arguments)
RED#
SCX= SCX?s SCX=a
SCX#
SCX?
SCX*
SLM= SLM?s SLM=a
SLM#
SLM?
SLM*
SNO? SNO? SNO=xxxxxxxxx
SNO*
SNO#
SWR? SWR? SWR=Boot:X.X.X
SWR* Bulk1:Y.Y.Y Bulk2:Z.Z.Z
SWR#
TAR= TAR? TAR=x
TAR?
TAR*
TAR#
TCI = TCI?s TCI =sx
TCI? (see description of
TCI * arguments)
TCI #
Revision 1
MN-CDM710G