Table of Contents
Advertisement
CDM-710G High-Speed Satellite Modem
Remote Control
Command
Arguments for
Parameter
(Instruction
Command or
Type
Code and
Response to
Qualifier)
Faults and
Status (cont.)
Description of Arguments
Query
E= Encoder FIFO Empty
F= Encoder FIFO Full
G= SERDES Parity Errors
H=Reserved.I=Tx Ais Interface 1
J=Tx Ais Interface 2
K=Tx Cable Interface 1
L=Tx Cable Interface 2
c=Rx Traffic Status
0=No faults
1=+1.5V Demod Power Supply Unit (Demodulator Card)
2=FPGA Load (Demodulator Card)
3=Demod Unlocked
4=FPGA Temperature (Demodulator Card)
5=Ber Limit excedded
6=AGC Level Out of Range
7=Eb/No Limit Exceeded
8=Demodulator Synth 1 PLL
9=Demodulator Synth 2 PLL
A=SERDES Demod to Framer
B=SERDES Framer to FEC1
C=SERDES Framer to FEC2
D=Reserved(Fast Options)
E=Rx DCM Unlocked
F=Slot 1 Buffer Underflow
G=Slot 1 Buffer Overflow H Slot 2 Buffer Underflow I Slot 2 Buffer
Overflow J=Framer SERDES Rx Fault (Interface 1)
K=Framer SERDES Rx Fault (Interface 2)
L=Rx Clock Source Slot 1
M=Rx Clock Source Slot 1
N=Reserved.
O=Rx AIS Slot 1 Port1
P=RXAIS Slip Slot 2 Port1,
Q=EXT Clock Slot1,R EXT Clock Slot2
d=New Faults
0=No new faults
1=New faults, since last check
e=Configuration Change
0= No Configuration Change
1=Configuration Change (cleared when read)
Response to
A–36
MN-CDM710G
Query
(Instruction
Response to Query
Command
Code and
Qualifier)
Revision 1
Advertisement
Table of Contents
