Comtech EF Data CDM-710G Installation And Operation Manual page 100

CDM-710G High-Speed Satellite Modem
Front Panel Operation
If Intfc1 Port1 Tx:
Intfc1 Port1 Status
Enable Disable
Using the
Disable to de-activate the transmit (Tx) side of Port1 and change the Data Rate to 0, then press
.
ENTER
If Intfc1 Port1 E3/T3/STS1:
Intfc1 Port 1 Rx:
Inv Data Buf Clk Ena/Dis
Select Inv, Data, Buf, Clk, or Ena/Dis using the
If Intfc1 Port1 Rx:
Intfc1 Port 1 Rx Data:
Normal Inverted
Select Normal or Inverted using the
If Intfc1 Port1 Rx:
Intfc1 Port 1 Data Rate
Rx: 34.368000
Intfc1 Port 1 Data Rate
Rx: Disabled
This is a read-only status window to display the data selected via the Intfc1 Port1:
menu. When Port1 Rx is enabled or disabled via Intfc1 Port1 Rx:
that status is reflected in this display. Note the following:
•
When Port1 Rx is enabled, the Data Rate associated with Port 1 is displayed, as shown in
the top example.
•
When Port1 Rx is disabled, that status is reflected in this display, as shown in the bottom
example.
Press or
ENTER
If Intfc1 Port1 Rx:
Intfc1 Port1 Rx Buffer:
Frame-Type Size ReCenter
Select Frame-Type, Size, or ReCenter using the
Ena/Dis is selected:
(
arrow keys, select Enable to activate the transmit (Tx) side of Port1, or select
Rx is selected:
Inv is selected:
( E)
Data is selected:
(E)
(E)
to return to the previous menu.
CLEAR
Buf is selected:
E)
arrow keys, then press
arrow keys, to control data inversion, then press
arrow keys, then press
6–24
Revision 1
MN-CDM710G
.
ENTER
ENTER
Type
Ena/Dis (see next section),
.
ENTER
.