Replacing The Hook Thread Bobbin - DURKOPP ADLER 512 Operating Instructions Manual

Operation
Operating Manual 512/532 Version 00.0 - 12/2013
1. Fit the bobbin (2) on the bobbin shaft (3).
2. Pull the thread through the guide (5) and around the
tensioner (6).
3. Wind the thread counterclockwise approx. 5 x around the
bobbin core (2).
4. Press the bobbin lever (4) into the bobbin.
5. Start sewing.
 The bobbin winder stops automatically when the configured
bobbin filling length has been reached (see Service manual).
6. Tear off the thread at the thread clamp (1) after winding.
Note
If the thread must be wound without sewing then the thread winding
mode can be set in the controller.
See  5.9 Bobbin winding, p. 40

4.5 Replacing the hook thread bobbin

CAUTION
Risk of injury from needle and moving parts
Only thread the hook thread bobbin with the sewing
machine switched off.
25