Table of Contents
Advertisement
Programming manual
2) Press the
3) Enter the secondary currency acronym (up to three characters) and press
4) Enter the current exchange rate and press
5) Enter currency flags; set the flags of secondary currency according to figure 3.20 and press
(S
).
UBTOTAL
New exchange rate is saved and printed at the same time. To change exchange rate it is necessary to
perform daily „Z" report. To modify other parameters of secondary currency it is necessary to perform daily
and monthly „Z" report.
ENTERING TEXTS INTO THE ECR
The numerical keys are used in text programming (logo, PLU names, cashiers names etc.). There are
numbers in the upper part of the keys and letters and other characters are in the lower part. In natio-
nal versions, all letters and characters of the alphabet are on the keys. To enter a capital letter hold the
(S
) key and press the relevant key. For instance, enter letter "a" by simply pressing the
HIFT
"F" by holding
and pressing the
"5" by pressing the
press
.
Characters that are not printed on the keys are „ '" (2 ×
×
), „ < " (4 ×
), „ > " (5 ×
(8 ×
).
If you want to print a double-spaced character, press the
before each double-width character. The double-width character is
displayed as character with space in front on the ECR display. If the
programmed text string has characters which are on the same key,
press the particular key as needed, wait until a full character appears
on the display, and then press the key again. If there are successive
characters that belong to different keys, simply press the buttons in
order without waiting. Mistakes caused when entering characters can
be corrected by
(C
PROGRAMMING OF THE OPTIONAL PROGRAMMABLE KEYBOARD KEYS
Programmable keyboard is optional accessory of ECR. If your ECR does not have this keyboard, you can
skip to next chapter.
Optional programmable keyboard contains 10 keys.
This procedure describes how to programme the programmable ECR keys. An individual key could be
programmed with arbitrary keystroke sequence (function keys, up to 16) that will be generated when the
programmed key is pressed in the future.
The programming of keys starts in programming mode
1.
The display shows the ID number of programmable key, the label „Key name" and the current name
assigned to that key.
44
(D
) key.
RAWER
key three times, number
key four times, to get the space character
), „ = " (6 ×
) key to clear the incorrect characters.
LEAR
(S
UBTOTAL
), „ ; " (3
), „ ? " (7 ×
) a „ $ "
key
. Press the key you wish to program.
) key.
Numeric keys
(S
) key.
UBTOTAL
key, letter
Advertisement
Table of Contents
Need help?
Do you have a question about the Euro-200T and is the answer not in the manual?
Questions and answers