Chapter 45 Ip Route Filter Command List (Ri Mode Only) - D-Link xStack DGS-3120 Series Cli Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
Chapter 45 IP Route Filter Command
create ip standard access_list <list_name 16>
config ip standard access_list <list_name 16> [add | delete] <network_address> [deny | permit]
delete ip standard access_list [list_name <list_name 16> | all]
show ip standard access_list {<list_name 16>}
create route_map <map_name 16>
config route_map <map_name 16> [[add | delete] sequence <value 1-65535 > {[deny | permit]} |
sequence <value 1-65535> [match [add | delete] [ip [next_hop | address] <list_name 16> |
metric <uint 0-4294967294> | route_type [internal | external | type_1 | type_2] | interface
<ipif_name 12> | route_source <list_name 16>] | set [add | delete] [next_hop [<ipaddr>] |
metric <uint 0-4294967294> | metric_type [type_1 | type_2]]]]
delete route_map [map_name <map_name 16> {all_seqence} | all]
show route_map {<map_name 16>}
45-1 create ip standard access_list
Description
This command is used to create an access list to filter routes.
Format
create ip standard access_list <list_name 16>
Parameters
<list_name16> - Enter the name of the access list.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an access_list named "list1":
DGS-3120-24TC:admin#create ip standard access_list list1
Command: create ip standard access_list list1
Success.
DGS-3120-24TC:admin#
45-2 config ip standard access_list
Description
This command is used to configure an IP Route access list. It is used to filter the routes.
List (RI Mode Only)
492