Config Cfm Lock - D-Link xStack DGS-3120 Series Cli Reference Manual

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
<uint 1-4294967295> - Enter the maintenance association index value here. This value
must between 1 and 4294967295.
mepid - The MEP ID in the MD which sends AIS frame.
<int 1-8191> - Enter the MEP ID value here. This value must be between 1 and 8191.
period - (Optional) The transmitting interval of AIS PDU. The default period is 1 second.
1sec - Specify that the transmitting interval will be set to 1 second.
1min - Specify that the transmitting interval will be set to 1 minute.
level - (Optional) The client level ID to which the MEP sends AIS PDU. The default client MD
level is MD level at which the most immediate client layer MIPs and MEPs exist.
<int 0-7> - Enter the client level ID here. This value must be between 0 and 7.
state - (Optional) Specify to enable or disable the AIS function.
enable - Specify that the AIS function will be enabled.
disable - Specify that the AIS function will be disabled.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the AIS function enabled and client level is 5:
DGS-3120-24TC:admin# config cfm ais md op-domain ma op-ma mepid 1 state enable
level 5
Command: config cfm ais md op-domain ma op-ma mepid 1 state enable level 5
Success.
DGS-3120-24TC:admin#
20-2

config cfm lock

Description
This command is used to configure the parameters of LCK function on a MEP. The default client
MD level is MD level at which the most immediate client layer MIPs and MEPs exist.
NOTE: This default client MD level is not a fixed value. It may change when creating or deleting
higher level MD and MA on the device.
When the most immediate client layer MIPs and MEPs do not exist, the default client MD level
cannot be calculated. If the default client MD level cannot be calculated and user doesn't
designate a client level, the AIS and LCK PDU cannot be transmitted.
Format
config cfm lock md [<string 22> | md_index <uint 1-4294967295>] ma [<string 22> |
ma_index <uint 1-4294967295>] mepid <int 1-8191> {period [1sec | 1min] | level <int 0-7> |
state [enable | disable]}
Parameters
md - Specify the maintenance domain name.
<string 22> - Enter the maintenance domain name here. This name can be up to 22
229